Our Services

We offer custom engine remaps for both diesel and petrol vehicles. Our maps are custom written in house therefore we can set your car up to your specifications, for example high torque, low torque or different power outputs as long as the vehicle is safe to do so. We carry out a number of tests and checks including diagnostics and data logging whilst we are modifying the cars engine software. Whilst carrying out these tests we check various amounts of data on the vehicle to make sure that we are keeping primary functions safe eg.exhaust gas temperatures and air fuel ratio. We will also perform before and after dyno runs on our all wheel drive dyno so that we can show you the increase in power that has been achieved.

DSG Gearbox tuning is available with our DSG software upgrade. As with all our ECU remaps each DSG tuning file is written for the vehicle and drivers requirements. The DSG gearbox remap includes the following functions:

• Increased Shift Response – the shift response can be increased by upto 20% resulting in a smoother transition giving a reduction of unnecessary clutch slip under full load acceleration which reduces clutch wear.
• Launch Control – this can be activated with most vehicles.
• Torque Limit Increase – the vehicle torque limiters are tuned as part of our ECU remap however the DSG gearbox has its own inbuilt torque limiters also. Through a DSG remap we can release the extra torque produced from your tuned engine.
• RPM Limit Increase – as with the torque limiter your DSG has control of RPM limits for each gear. Increasing these shift points gives the driver full control and command of the engines power in the upper RPM ranges and we will set the DSG rev limit to work with your current engine set up.

A power run is a simple test we can run to show the bhp and torque your car is producing at the wheels. We can also approximate the power at the flywheel. Your car will be put on the rollers and two to three runs will be done to make sure any particular run does not give a freak result. We record the following results for each car run:

• BHP at the wheels
• Torque at the wheels
• BHP at the flywheel
• Torque at the flywheel
• Boost pressure(forced induction only)
• Air/fuel mix

We can plot all these variables against each other, giving you a clear picture of how your car is running.

Power runs take around 45 minutes and are priced at £100. Some big power/rare cars require extra time to setup on the rollers, we may charge more than standard for these cars, but if this is the case we will advise you when you book.